Enables or disables fast-reroute protection for the specified LSP.
| lsp_name | Specifies the name of the LSP you are configuring. |
Disabled.
To signal the fast-reroute protected LSP, use the enable mpls rsvp-te lsp [lsp_name | all] command. Similarly, to disable the fast-reroute protected LSP, use the disable mpls rsvp-te lsp [lsp_name | all] command.
This command enables fast-reroute protection on LSP aus:
configure mpls rsvp-te lsp aus fast-reroute enable
This command was first available in ExtremeXOS 12.1.
This command is available only on the platforms that support MPLS as described in the Switch Engine v33.1.1 Licensing Guide document.